Shop Notes
CNC routing hardwood with clean edges.
BH
Bitteroot Hardwoods
Clean CNC-routed edges on hardwood and plywood come down to three variables. Dial these in and you'll get glue-ready edges with minimal sanding.
Bit selection
A compression bit — up-cut at the tip, down-cut on the shank — leaves clean top and bottom faces on plywood and veneered panels. Match bit diameter to your smallest inside radius.
Feeds and speeds
Chip load is everything. Too slow and the bit rubs and burns; too fast and it tears out. Aim for a consistent chip that clears the flute rather than dust.
Climb vs. conventional
A climb-cut finish pass leaves the cleanest edge on solid hardwood, while a conventional roughing pass keeps the part stable. We nest and tab parts so they hold until the final pass.

